Larsen steel sheet pile construction will inevitably encounter some difficulties. Below the Wuhan steel sheet pile small series, some details need to be paid attention to during the construction of the steel sheet pile. I hope that it can bring more convenience to everyone.
First of all, if the Larsen steel sheet pile is inclined in the axial direction during construction, the shaped pile can be selected to correct. The shaped columns mentioned here are generally wide and narrow, or the width of the steel sheet pile is larger or smaller than the standard width; the special-shaped columns can generally be welded according to the actual inclination of the construction site. Therefore, it is very convenient during the construction process. Of course, if the inclination in the axial direction is not too large, it is also possible to use a steel cable or the like to pull the steel sheet pile in the opposite direction and hit the hammer.
When Larsen steel sheet piles are constructed, sometimes the problem of insufficient pile pile depth is encountered; at this time, it is necessary to check whether large stones or other obstacles are encountered. Once you encounter a large obstacle that cannot be moved, you can use an arc-shaped pile or a special-shaped column to bypass the obstacle if necessary.
Finally, we all know that the Larsen steel sheet pile pre-buried mixed soil will often be laterally squeezed by the stone during the process of extrusion. Because the pressing force is different, it is easy to appear skew. In this case, it is best to pull the steel sheet pile upward in the deflected position and then hammer it down, so that the large stone can be deflected or shattered by reciprocating up and down several times, thereby deflecting. The steel sheet pile was corrected to reduce the inclination of the Larsen steel sheet pile.
